![]() ![]() Better detection: Their extra power also means better detection distances, faster speed and brighter IR LEDs.More cost effective: Higher voltage and current leads to far better performance and much longer battery life and thus much more cost-effective in the long-term.A camera trap needs a minimum of 2500mAh to power the LEDs at night and Lithium’s have around 2900mAh – much higher than other battery types Higher battery current: The other magic number to look out for is the mAh – or milliamp hours.Longer lasting: They last about 5x longer than alkaline batteries.Unaffected by the cold: They don’t care about cold temperatures, performing as normal down to -15C.When new, Lithium’s are around 1.85V per battery compared to alkaline at 1.7V and rechargeable at 1.2V! This means they run off 8 batteries all at once and need at least 1.5V from each battery. High voltage: The technical bit – trail cameras are either a 6V or more commonly, a 12V system.We don’t use anything else in any of our own projects and here’s why: We always recommend Lithium AA batteries, and specifically Energizer Ultimate Lithium. This will start a cycle of the batteries having just enough juice to trigger and start recording, but not enough power to keep the recording going. That means that although there may be enough power in the batteries to trigger the camera and allow the LEDSs to come on, they will struggle when it comes to actually recording. ![]() However, when it starts recording, especially at night, it needs much more power and the batteries are put under a much higher load and the current they give out can fall – especially if they’re not very good. The camera needs very little power to simply just switch on and light up the screen, so when you do this, the batteries will report that they’re happy. Unfortunately, the battery meters are not very reliable – what’s important is the load on the batteries. but has stopped taking videos/photos overnight or is taking shorter videos than set – essentially it just means that it’s time to change the batteries. One of the most common concerns people come to us with is that their camera says the batteries have 2 out of 3 bars or 90% left etc. Turning the camera on but the battery percentage or bar going down steadily, then turning off.Taking a picture but no video in hybrid mode (Bushnell Core, Spypoint, Ltl Acorn).If you’re experiencing any of the following issues with your camera just change the batteries: In fact, the majority of issues that we hear about are resolved when batteries are replaced. Many of the issue’s camera traps experience are due to flat, low power or just poor-quality batteries. We always recommend using Lithium batteries for optimum trail camera performance Here we’ll explain how and why battery choice is so important including our recommendations for best performance and which ones to avoid (hint… its Duracell). Batteries: why it matters which ones you chooseīatteries are the number one cause of issues in trail cameras and the type and brand of batteries you use will determine how well it performs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |